Washing Your Airplane – A Quick and Dirty Guide


Cleaning your plane is just the same as taking care of your car. However, the majority of pilots maintain their aircrafts regularly cleaned those who have their own toilets on planes are likely be among the few.

The reason why people don’t be afraid of being at a disadvantage. Don’t be afraid! This article was written to ensure that you have everything secure!

Why You Should Wash Your Plane

There are numerous reasons why you should be sure to clean your plane on a regular basis. It will improve the overall appearance and condition of your plane, even if you hire an outside company to wash it.

Cleaning your plane is an act of relaxation. The plane you bought was bought to have fun It’s not a reason to not have fun washing it too. Think about washing your plane in the same way as you fly it. It’s an escape from the bustle and hustle of your daily life.

The washing process also has the potential to enhance its efficiency. Debris caused by bugs or other matter that is organic car detailing near me could increase the force of drag while flying. If you keep your plane clean often, you’re aiding in making it the most efficient aircraft that it can be!

In addition, you’ll help the plane move faster because washing it regularly will enable you to spot any issues before they become a problem. When you look over your aircraft during washing, you’re providing yourself with the chance to shield your aircraft against any gas stations nearby from any potential problems such as corrosion.

Regularly cleaning can assist in keeping the paint safe. Regularly cleaning it, and sometimes waxing and polishing can keep your plane looking newer for longer.

In addition, it helps in saving cash. Prices for washing your aircraft may vary, but there is one thing for certain hiring an outside company cleaning your plane could cost a lot! It is possible to save money by washing yourself.

Why You Aren’t Washing Your Own Plane

Whyaren’t you washing your airplane? We know that there’s no excuse being lazy. Perhaps you’re busy however, not lazy. If you’re deicing your plane during winter, you’re prepared to wash your plane!

The principal reason people do not buy planes is anxiety. The cost of flying is high, as well as you wouldn’t wish to ruin the whole thing. However, what’s the most difficult are the systems that are a pitot.

The Pitot-Static System

The pitot static system is comprised of several instruments sensitive to pressure found on planes. They assist in measuring altitude and speed. They are essential instruments that are able to help in the event that you’re thousands of miles above the surface.

The most frequently used pitot-static instrument components are:

  • Static ports
  • The pitot-tube

As you’re likely aware, the damage caused by these tools could result in further issues and grave accidents. This was incidentally and widely linked to pitot-static components in 1996.

The foremost thing to remember about this incident is that it was not caused by the sensor being wet. It was due to the plastic protective layer that was not totally removed from sensor following washing them.

The pitot system on the plane is not working, it can be difficult. There is a solution. This is how to use the “poor man’s” solution. However, you may be able to think about a custom pitottube cover to give you that extra security.

To locate a “poor man’s” solution, you’ll need:

  • Plastic or any other waterproof material
  • Bright-orange banner tape

Once you’ve achieved that then you’ll be in a position to:

  • Guard your ports as for instruments by using waterproof materials
  • Make sure the material is secured using the tape

The use of tape that is brightly colored is crucial. Like we said, the accident in Peru was the result of a plastic cover being put on sensors. A brightly colored tape will draw your attention quicker and remind you to remove the cover.

It’s perfectly normal to feel in awe when you wash your plane. They’re costly, and you may be worried about the likelihood of damaging your plane. If you take your time and effort, you can ensure that your plane is clean and be sure that you’ve done everything to avoid any risk.

Washing Your Airplane

We’ve talked about the benefits cleaning your plane and what’s stopping you from doing it yourself. Once you’ve seen an increase in confidence and confidence, it’s the right time to get started. There are some steps you need to take and the end result is well worth the time and effort.

You’ll need:

  • A water hose
  • Clean towels
  • Mild soap
  • A degreaser safe to use that’s aluminum-safe for use on the underbelly
  • A micro-fiber glove
  • A bucket
  • Plexiglass cleaner
  • Bright-orange banner tape
  • Waterproof plastic film
  • Rubber gloves
  • Goggles or eye protection
  • A creeper for getting under your plane


The dirt and bugs can serve as sandpaper for your paint. The first step is to wash away the organic matter with water or by using your hands.

  • Then, set your hose to an easy flow, and allow it to flow across the space you wish to cover.
  • After you have soaked the towel, make sure you use your hands to take any dust off the exterior

If you’d like to utilize an insect-friendly cleaner that dissolves insect proteins. Use a specific cleaner for aviation. The common cleaners contain abrasiveswhich could grind into the dirt and harm the paint.

You’re probably eager to put on your microfiber glove, but a plain hand is preferable in the initial phase. Utilizing your hands without hands lets you feel the plane’s surface, and aids in the removal of any rest of the particles. This is helpful after you have used soap and water to keep the particles from being sucked into the surface of the painting.


Cleaning the underbelly clean to wash takes a little more elbow grease than cleaning the “sunny side” of your plane. It’s one of the areas that is most difficult to clean and therefore it is important to take your time and don’t rush it. It is possible to cover a tarp with the area to collect any debris that falls , which will reduce cleaning process.

Remember that the location of your wings may affect the speed at which you can clean the surface on your wings. The planes with higher wings will be easier to manage while low-wing planes might require some bending and scooting.

Once you’ve completed this:

  1. Make sure to wear eye protection as well as gloves.
  2. Get under your plane using your creeper.
  3. Clean the interior of your plane to get rid of any dirt that may be accumulating.
  4. Apply your aluminum-safe cleaner to the surface.
  5. Remove the dirt.
  6. Repeat the process until you’ve eliminated as much as you can.

It’s time to move on to cleaning your aircraft using soap and water after you’ve done debugging , cleaning and degreasing your plane.


The selection of soaps isn’t simple. The reason lies in the mix of aluminum and paint which is the outer coating of aircrafts.

Many soaps and cleaning supplies contain alkaline which could:

  • The paint will eventually turn dull.
  • The aluminum will weaken faster due to chemical reactions that are triggered by cleaner

A lot of pilots opt for a simple dishwashing solution to keep their aircrafts clean.

If you’re planning on going for a higher-priced option, make sure you choose an item specifically designed for aviation use. This will eliminate the chance of corrosion that is too long or dulling for the finish or aluminum.

If you’re cleaning your plane, you should do the following:

  1. Spray the desired area with the water with a gentle flow.
  2. Combine soap and water in an empty bucket
  3. Be sure to soak your glove in microfibers in the solution.
  4. The area to be cleaned is to be cleaned using the glove that was thoroughly soaked
  5. Make sure the soap is clean using water

Once you’ve cleaned your plane using water and soap It’s time to get onto the glass.


Make sure you’re using the appropriate plastic cleaner when cleaning the glass. Use a soft and absorptive towel inside your purse.

  • Spay the plexiglass by cleaning it with cleaner
  • Clean the dirt off using your towel

It’s time for you to finish the necessary steps for washing the exterior and interior of your aircraft! Make sure to take off the tape and the plastic that you put on the pitot static system of your plane . And then you’re all set to fly!


There are numerous theories of the idea of the process of polishing or waxing aircrafts. Some say you don’t need to clean your aircraft on a regular basis. If you choose to go the an extra mile, apply wax and polish it at least once every six months.

Also, make sure you apply wax and polish on your aircraft each time you polish.

This article will show you how to clean the outside and inside of a plane. It is necessary to clean the inside for the purpose of getting as thorough as you can.


It is tempting to make an error when cleaning your plane. Don’t! Be sure to:

  • Making use of a pressure washer since this could result in water in areas which should be dry
  • Mechanical buffers can be used for this.
  • It is not advised to wash too often.

Following the guidelines in this article can help keep your plane looking good longer. As with flying, cleaning your plane should be a pleasurable task. After you’ve completed it several times and you’re getting familiar with the routine, you’ll begin to wonder what you paid someone else to do it.